Oval Flip-Top Cap Mould for Silicone Valve Closures

Oval flip-top caps, separate silicone valve and steel mould
Concept rendering of oval flip-top cap tooling and a separate silicone valve. The complete cavity layout is not shown.

The most useful sample for quoting an oval flip-top cap mould is the assembled pack: the bottle, the cap and the silicone valve. Each part answers a different question. The bottle shows how the cap snaps into place. The cap shows how the lid lines up with the body. The valve shows how the moulded seat must hold it.

Mincong builds custom injection moulds for the plastic closure. If your design uses a one-piece flip-top, the lid and body are moulded together with an integral hinge. The silicone valve is a separate component fitted after moulding. We review the valve interface as part of the cap tool and list any valve supply or assembly requirements separately in the quote.

Request a custom tooling quote: Send the cap drawing, bottle neck drawing and silicone valve specification.

What we review before quoting an 8-cavity hot runner tool

An eight-cavity hot runner layout is one option for this type of oval closure. Before confirming it, we review the actual cap profile, the selected resin and the press available at your plant. Send the length and width of the cap in its moulded position as well as the closed dimensions. If only the closed dimensions are available, send the CAD model so the tool layout can be checked against the open lid and hinge.

What the buyer sendsWhat we review before finalising the quote
Cap CAD model and a sample, if availableLid alignment, hinge position and whether the part can release without damaging the snap features
Bottle neck drawing and bottle sampleSnap engagement, cap seating and whether the oval cap needs a fixed orientation on the bottle
Valve drawing and sampleSeat dimensions, valve retention and the direction in which the valve is installed
Press specification and production targetCavity layout, tie-bar clearance, mould height, opening stroke and the hot runner interface
Steel grade or documentation requirementsExact grades quoted, where each grade is used, and whether proposed alternatives need approval and supporting documentation

Check the plastic cap and the assembled pack at trial

Start with moulded caps identified by cavity. Check that the lid closes cleanly and that the hinge and snap features hold up through the agreed opening and closing checks. Then fit the approved valve, snap the cap onto the intended bottle and test the complete pack.

If a trial pack leaks, identify whether liquid is escaping at the neck, around the valve seat or through the dispensing opening. That distinction tells the team which interface to inspect before changing the mould. Agree on the test liquid, fill level, bottle orientation and acceptance criteria before the trial so that both sides judge the same result.

Request a quote for your oval flip-top cap mould

Send your cap model, bottle neck drawing and valve specification, along with the press model and target output. Let us know whether the quote should cover the mould only or also account for lid closing, valve insertion or trial sample assembly. We can then state what is included and what needs separate review before you compare tooling prices.

Request an Oval Flip-Top Cap Mould Quote

Related Moulds