Why Is There a Gap Under Your Spray Pump Overcap?

Why Is There a Gap Under Your Spray Pump Overcap?

The overcap looks flush in the CAD model. On the filled-pack sample, you can see a gap above the shoulder. Trimming the lower edge will not help if the inside of the cap is already resting on the actuator. First establish what stops the cap from travelling farther.

Compare the same parts in three assemblies

  1. Bottle with pump only: Check that the pump is fully seated as specified. Measure installed height from a repeatable bottle datum.
  2. Overcap on the approved pump or fit fixture: Check where the cap grips and whether the inside roof contacts the actuator before the retention feature seats. Do not push the cap down far enough to actuate the pump.
  3. Complete pack: Measure the gap around the shoulder. If the gap is larger on one side, check cap tilt and concentricity before assuming the whole skirt is too short.
ObservationNext check
The cap stops high before it gripsCompare the inside depth with the installed pump height and check for roof contact.
The cap grips, but the lower edge touches the shoulder in one spotCompare the inside edge profile and shoulder shape. An internal relief may be appropriate after confirming the contact location.
The gap appears with only one incoming batchSwap one component at a time with an approved sample and see which component the gap follows.

Agree on a visible-gap limit and removal force using the full assembly. Keeping an approved bottle, pump and cap together gives both the mould maker and the buyer the same physical reference.