ENGINEERING NOTES
A PET preform programme should qualify the proposed recycled or reground feedstock before changing the mould to accommodate an unstable first trial. Identify what the material is, whether the preparation and injection system can handle it, and which preform and bottle results must remain acceptable. A percentage on a blend sheet does not establish those conditions.
AI concept illustration. Pellets, flakes and preforms are generic and do not establish material purity, recycled content or food-contact suitability.
Keep regrind and post-consumer rPET distinct
For this project discussion, use “regrind” for identified material produced by grinding a defined production stream, and state exactly what entered that stream. Use “post-consumer rPET” only when that source is documented. Purchased recycled pellets, flakes and an internal reject-preform stream should not be treated as the same feedstock merely because each is labelled PET.
Ask the supplier to identify the grade or specification, source category, physical form, conditioning and relevant application documents. Clean-looking flakes do not establish removal of contaminants or suitability for a specific food package. The packaging and material owners must confirm application suitability before the material enters an approved production route.
Match the feedstock form to the installed preparation route
Check whether the proposed material can be metered, conveyed and prepared by the actual equipment. Confirm how fines, particle-size variation and differing bulk behaviour will be handled. Where crystallisation or a different drying arrangement is needed, resolve that with the material and equipment suppliers before scheduling the mould trial.
SIPA describes recycled PET supplied as pellets or flakes and discusses processing challenges associated with heat history. Its specialised systems are examples of engineered solutions, not evidence that any existing preform line accepts any recycled flake. For the detailed moisture investigation, follow the PET preform drying article; this page addresses the feedstock decision around that process.
Qualify a controlled candidate rather than a moving blend
Keep the incoming material, proposed blend and colour system identifiable. Compare a defined candidate against the accepted reference under an agreed trial plan. Do not simultaneously change the feedstock source, recycled proportion, colour and tooling geometry if the purpose is to understand the effect of one material change.
The resin supplier should define the relevant material acceptance properties. Discuss intrinsic viscosity, colour, moisture and contamination controls where they matter to the application, and agree how the preform result relates to the incoming material. A certificate for incoming resin does not by itself prove the material state after preparation and injection.
Solve the observed process limitation before correcting steel
| Trial finding | Practical response |
|---|---|
| Feed or preparation is inconsistent | Correct the identified handling or equipment limitation; do not compensate with random moulding adjustments |
| Appearance or material properties deteriorate during processing | Review the candidate's heat history and the system's operating window with the responsible suppliers |
| Stable preforms are produced but bottle performance changes | Investigate the material and preform-to-bottle interaction before accepting the candidate |
| Results pass only for one unrepresentative lot | Keep approval limited to the tested scope and resolve how future lots will be controlled |
| Application documentation is missing | Keep the candidate outside the approved application until the responsible parties resolve it |
Changing gate geometry or wall distribution may eventually be appropriate for a redesigned programme. It should follow a decision about the material and bottle requirement, not conceal feedstock variability. Our weight and wall-thickness guide explains the separate geometry question.
Release a material route with clear limits
Agree which feedstock specification, blend, colour, equipment and test results the approval covers. Define the event that requires another review, such as a source change, a material-property departure or a new bottle application. Keep a rejected candidate separate from accepted production stock.
For a new PET preform mould project, send the intended feedstock specification and preparation equipment information alongside the bottle and preform drawings. Runner, cooling and removal can then be reviewed against the actual production route. This article does not claim a Mincong recycled-content trial or establish a universal permissible regrind percentage.
Request a preform tooling review with the material route clearly identified, so the proposal states what needs validation and who is responsible for each stage.
Technical references and scope
References checked on 2 November 2026. Supplier documents describe their own materials or equipment. Project review and acceptance proposals above need confirmation for the actual product, material and production system.
