During an automatic closing flip-top cap mould trial, check hinge condition, ejection, lid alignment, snap engagement and consistency across cavities and repeated cycles. Agree on the closing route first: in-mould closing integrates the movement into the mould, while external closing uses separate equipment after moulding. A good-looking cap from one shot does not establish that the complete sequence is repeatable.
Start with the cap and hinge
Confirm the intended opening angle, hinge thickness and lid-to-base alignment against the approved design. Inspect the hinge after moulding and after closing for whitening, distortion or damage. The resin and process settings matter, so the trial should use representative material. For the design-stage inputs, see our PP flip-top living-hinge design guide.
Observe ejection and closing as one sequence
Watch how the cap leaves the cavity, where it is supported and when the lid moves. The closing mechanism must suit the cap geometry and the available movement inside the mould. Check for contact marks, incomplete ejection, lids missing the target position and variation between cavities.
Inspect the finished closure
After closing, assess the snap fit or locking feature, appearance, dispensing opening and any relevant sealing surfaces. Samples from different cavities and repeated cycles are more informative than one successful shot. Record the machine settings and what was adjusted so the result can be repeated.
Information to agree before the trial
A drawing or physical cap sample, resin grade, target output, injection-machine details and acceptance criteria help define what a successful trial means. If robotic handling or an external closing line is planned, make that part of the discussion from the start.
See our flip-top cap mould page for closure examples, or send your cap design for an engineering review.